Cogan Blog
Insights, guides, and industry trends on mezzanines, industrial storage, and warehouse optimization.
Articles are compiled from publicly available industry sources for informational purposes only. Images are illustrative and actual products may vary.
Wire-Mesh Partition Installation: A Site-Readiness Checklist
Prepare for a wire-mesh partition installation by confirming the approved layout, supporting conditions, access openings and building interfaces. The appropriate instructions depend on the selected enclosure and gate configuration. A general checklist can organize the project, but it should not replace the relevant manufacturer documents.
Outdoor Cantilever Racking: Finish, Roofing and Site Planning
Outdoor cantilever racking needs a design that accounts for the stored loads and the site's environmental and support conditions. Finish selection, drainage, foundations or slab conditions, and any roof are part of that discussion. An indoor rack should not be moved outdoors or fitted with a canopy without review.
Removable Warehouse Guardrails: Planning Maintenance Access
A removable guardrail can provide temporary equipment access within a planned protective boundary. Its value depends on a defined opening, the correct manufacturer-specified components, and a clear process for controlling the area while the rail is out and restoring it afterward.
Industrial Partition Walls: Dividing a Warehouse Without Blocking Work
An industrial partition layout should define the area that needs separation while preserving the movement, access and services required around it. Start with the reason for the boundary and the work performed on both sides. A partition is most useful when its doors and dimensions fit the operation it encloses.
Single-Sided vs Double-Sided Cantilever Racks
Single-sided cantilever racks provide storage access from one side of the columns; double-sided configurations provide arms on both sides. The choice depends on available access, load distribution, handling routes and the approved structural arrangement. Double-sided does not automatically mean twice the usable capacity of a given floor area.
Single vs Double-Rail Guardrails for Industrial Facilities
Single- and double-rail guardrails provide different vertical coverage. Choosing between them starts with the equipment or area being protected and the expected contact exposure. The number of rails does not, by itself, establish the complete system's impact performance or suitability for an elevated edge.
Sliding vs Swing Gates for Warehouse Partitions
Choose a partition gate by its clear opening, operating space and access task. A swing gate needs room for its leaf to move; a sliding gate needs an appropriate travel and support arrangement. Neither should be selected from opening width alone.
Cantilever Racks for Sheet Material: Supports, Overlays and Access
Sheet material storage needs support across the intended load and a handling method that keeps the material controlled during placement and retrieval. Cantilever racks may suit the application, but arms, overlays or other accessories must be selected for the specific material and approved rack configuration.
Forklift Barriers: How to Read an Impact-Rating Claim
A forklift barrier rating describes performance under specified conditions. It should be read with the tested configuration, vehicle mass, speed, impact direction and installation requirements. A headline number alone cannot establish whether a barrier suits a particular warehouse exposure.
© 2025 Cogan Wire and Metal Products Ltd., all rights reserved.